How to make 8 treatment device(trimmer table)

One example of usage

	The base is joined with the trimmer. Because the amount of cutting changes depending on the installed height, it will fine-tune it later by installing it first of all suitably.
	The sending stick is stopped by clamping by two places.
	Because the amount of cutting changes by the position of this sending stick, the trial cutting is done several times, the exact location is decided, and it does. It is easy to fine-tune it when lightly beating with the hammer after clamping is loosened when the position is moved.
	Cutting slides [zai] contrary to the direction where cutlery turns (This is faced and called cut). Only this of the usage left is the super-easy.
	Various processings can be done by the installed bit. The left was processed to about 5mm in the respect width by installing the bit of 45 degrees.
	Here carved the ditch by installing a straight bit. It is possible to do here by trimmer one of a processing ..round [nokodeyaru].. difficult.