Speaker pursuit road > the technological chapter of woodwork top of Oyama [mikioto] >

When the size was outside assumption

  It is ..error margin.. [detekimasu] by may always say by you that it will assemble the cut plywood. will be likely. It doesn't go to normal means because wood shrinks even whenever those causes are various and the cutting accuracy is perfect. How should general people who cannot do it deal though man involved in woodwork can do a very easy correction by a large-scale table saw and the press machine, etc.It brought it together.

�@Upper and lower front, back, left and right [hi] repeats wood.
  The China plywood etc. that are put the veneer on both sides might stick exactly due to the distortion when the board is upset. A good position might be found now.

�AIt has the gap of the size in an unremarkable place.
  It is a method effective though this method is given a kind of method. Respect in the baffle side and the bottom will exactly join because it is important, and throw the size of the gap into the back basically.

�BWood is bent and it bonds forcibly.
  It can curve to some degree if the edge uses sleep etc. because wood has considerable compliance unlike the metals etc.This method can be considerably used when remembering though is limited the part that can be applied. It is possible to join it the more thinly the area grows basic board thickness, the more easily wood being bent.

�CIt cuts down with the canna and paper and it corrects it.
  Another doesn't have a tool as convenient as this if it remembers though a technology constant though it uses is needed to [shukanna]. The method of the beginner's correcting the gap with the canna sandpaper doesn't come too recommended, except when only this method exists by all means. There is a possibility that the start or the gap grows in the worst-case scenario.