Speaker pursuit road > unit terminal the chapter top >

Obtaining of [fasuton] terminal and internal wiring

  The [fasuton] terminal, the unit, the [fasuton] terminal, and the terminal these are joined by using solder. It might be severe in [acchaku] at the radio pincers level though there is a theory assumed that bonding dislikes disadvantageous information on the lead used for solder and is possible only also by [acchaku], too. It introduces the bonding method in can solder here as it is a formula.
  There is no rule in this though it hesitates for which unit to only have to use the [fasuton] terminal of which size and the small caliber unit might have to use a considerably large [fasuton] terminal. It is likely not to embarrass it two when three kinds are bought because it is not the too expensive one the one of a different size.

	The [fasuton] terminal of the size of the unit used is inserted in the unit and it confirms it.
	Because it will be adjusted later, loosely or it doesn't worry even if not entering now and the [fasuton] terminal is safe though it is unnecessary when it is too hard usually.
	It is not easy to usually enter with internal wiring and the [fasuton] terminal because the mouth on the [fasuton] terminal side is narrow.
	The mouth of the [fasuton] terminal is expanded with two pincers.
	Comparative picture.
	It puts on pressure with pincers when the cable passes to the [fasuton] terminal and solder is poured.
	Bonding completion.