Speaker pursuit road > the technological chapter of woodwork top of Oyama [mikioto] >

Tool used for pressing

    When wood was bonded, the importance of pressing [surukoto] was described ahead. The woodwork bond should put paper and joining [rutameno] .." paste ".. put big pressure unlike. The tool that there is no large-scale press machine general uses is sure to become the following three though pressing [suruno] changes the tool used depending in each place.

	Edge(clamping)
	When a large-scale speaker is united, it needs it by about 20. The one indispensable for shroud bonding of backing loading horn. If a lot of numbers are used, power like a simple press machine is demonstrated. A deep clamping the bosom is especially expensive.

	Wood screw
	It uses it for the place where clamping doesn't reach in the sound road part of cannot the purchase of the edge of a necessary number of sleep, and backing loading horn. Externals worsen if Dubbo is not buried though it is possible to use most easily and low-cost. As for the pressing in the wood screw, the effect is greatly different according to the wood used.

	Weight
	The photograph is TG metal it is crowded 13k and with one. The author owns three. The effects of the [naruto] pressing are somewhat [detekuru] at this level though it additionally becomes 40k three. However, when it compares above by two [tsuto], it is not strong. You may think most to be ineffectual in extent in which the book and several dictionaries are put.