Speaker pursuit road > the technological chapter of woodwork top of Oyama [mikioto] >

Way of Dubbo burial

  The edge's of all doing to the pressing [suru] ..wood.. side by sleep etc. also has the place where the wood screw should be used by all means very difficultly realistically. It becomes beautiful in the design if the hole is buried in Dubbo at such time. There are two kinds with the target one to hide the head, and the method of the introduction here is latter though Dubbo was connected to the one connected by it with the wood screw.

  If there is a round stick that can be obtained in the machine and the do-it-yourself store vertically punctured, Dubbo is made hurried and beautiful. The point to be noted is to take the size of the Dubbo hole smaller than the size of Dubbo. For instance, when a round stick of the diameter of 10mm(Dubbo) says to the hand, the made hole (Dubbo hole) punctures it by using the drill of the diameter of 9.5mm. Then, wood shrinks moderately and beautiful Dubbo can be made exactly.

	First of all, a vertical hole is made with the drilling machine etc.The photograph has inserted an electric drill in the bench drilling machine.
	The machine screw is massaged with the wood screw and it crowds.
	It becomes smooth needing to take respect on the round end of a stick edge.
	When the bond is put in the Dubbo hole, a round stick is hammered and it crowds.
	Dubbo of the remainder can be cut without damaging surrounding plywood when there is a saw in Dubbo.
	Paper is appropriated and flattened.