Speaker pursuit road > unit terminal the chapter top >

How to install [onimenatto]

  The worst baffle is no use and there is a possibility of becoming it without getting damp ..all the machine screws.., too, if the installation of [onimenatto] is considerably difficult, and it doesn't position it accurately. The most important point is to take the position accurately, and to appropriate the drill vertically.

	Two kinds of [onimenatto]
	It hammers and there is the one of a crowded type in [onimenatto] with the one of the type turned with a hex-head wrench.
	It hammers and the explanation of a crowded type.
	The unit takes the position of the center accurately. This positioning is considerably careful.
	Hole opening by drill. It is borne in mind to open it vertically. If it is possible, I want to do with the drilling machine.
	When the hole opening is finished, [onimenatto] is driven with the hammer.
	Driving from the other side goes up and degree of adhesion goes up though it is also possible to strike [onimenatto] from the table side of [bafuru].
	When seeing from the table.