Speaker pursuit road > the example of producing Nagaoka [tetsuotoko] speaker top >

Production 9 of D-88 super-flamingo

81
	Bonding of head backboard. Because here cannot use the wood screw, it is only clamping and pressing [suru] in strength.
82
	Installation of baffle. The nut with the fingernail is cut down and installed. When the nut with the fingernail and demon [menatto] are used, you should confirm whether the unit is installed once without fail and the position is correct. It is possible to correct it comparatively easily if it is at the time of this even if the position shifts.
83
	[Ru] ..strong.. ..pressuring well-set.. ..becoming empty... use six clamping
84
	Union in head problem and body.
85
	The plane is checked without fail before it applies it as well as time when the bottom plate was applied.
86
	The edge bonds surroundings with sleep, and a central part is a machine screw stop. Spreading �� edge of the bond is sleep and �� machine screw stop of the turn that wipes bonding �� bond off. This is race against time. Sleep etc. begin by the edge and after length is set, and Wess etc. also set it, begin work.
87
	. with the plane ..unevenness [hara].. ..saying... continue13, 14, 15, 24 of the heads, and 25 were ordered 1mm more greatly this time.
88
	Method of cutting down turning with plane. It requires a lot of skill in putting out the plane to four. A detailed by far is completely paid by this method.
89
	..hardness.. [ikoto] [kata] [ikoto] of [finrandoba-chi]. It sharpened it the blade of the plane and twice by terrific hard. In addition, this [ba-chi] plywood was a little stickiness, and had a hard time in the treatment of putting it unusually the surface.
90
	Bonding of the last board. Clamping and the edge stop the back and forth by sleep, and pressing [shimashita] in a central part by three tg metals.