Production 5 of D-88 super-flamingo

41
	Board (7+8+9) that is scheduled to be put up continuously is put, and it is fine-tuned that the by far is not caused at the position of board 2 and 6.
42
	Fixation ��TG three metals are put to clamp about this time.
43
	It upsets it, and when it does by about 30 minutes and it is confirmed not to have moved, it is clamping and a temporary stop.
44
	The hole in the under is dynamically made by an electric drill, and machine screw [wowo] is put. This work is not significant if it doesn't do before the bond finishes drying completely. The reason for the space with the possibility of making it to the sound road part is that it is a purpose to put on pressure with the machine screw.
45
	1+2+3+4+5+6 is completed.
46
	Seemingly, from the table. 22 machine screws were put.
47
	(1+2+3+4+5+6)Bonding of (7+8+9). solving(7+8+9)..[i].. [okima] is the most important. drinkWhen the bond is put, it puts on the board of flat and the right angle is confirmed from four directions. If this work is not done, it becomes a hexahedron to which the body part in Swan is distorted.
48
	Do the board from back and forth or it becomes vertical and the horizontal though [sukoya] is appropriated and it existed ..coming in succession...
49
	Check from the right and left.
50
	It checks it by ideally using large-scale [sukoya] like the photograph.