Speaker pursuit road > the example of producing Nagaoka [tetsuotoko] speaker top >

Production 8 of D-88 super-flamingo

71
	When the foundation adjustment is finished at this point, the completed problem part is easy because it is ..paper.. ..[kesuruno].. difficult later. It is light in the plane and chamfering of ..saying.. �� of unevenness [hara] �� paper disregards it.
72
	Bonding of problem part and 26. Every time, here nails it because it is scary only in the bond on strength. It changes to the wood screw to increase strength or more this time. It is possible to work with stability as shown in the photograph when L and R are alternated. The wood screw is put when drying to some degree. Because the head of the wood screw knocks against here when uniting with the body, it should be [ireru] in the drill as for spot-facing.
73
	An electric drill is done to outside the wood screw when here fails without using it by the hand work with [utokonano] ..dashing out...
74
	20 also similarly drives bonding �� wood screw. The thromboresistance part lightly erases by paper and does the chamfering. The sectional area of thromboresistance changes if it does too much.
75
	Because 21+22+23 processes a big chamfering back as a trimmer, it bonds only with clamping. The wood screw cannot be used.
76
	It is in obtaining internal wiring. It is easy to have done this time though the terminal used this time can be installed even after the speaker is completed.   It is a combination of an original cable of the Egawa atelier with the terminal made by material terminal tri Tec used. It is easy to use this cable for making by oneself because it is not very Futoshi too much. The quality is my favorite often.   In addition, the [fasuton] terminal that gives the silver solder, special solder [gote], and the gold plate of the tone quality valuing is used.
77
	First of all, the hole for the terminal is made for the board that installs the terminal.
78
	A gold-plated [fasuton] terminal is installed in one of internal wiring. (how to install [fasuton] terminal)
79
	The terminal where the baffle was passed through one is installed.
80
	When the machine screw is stopped to the board, the installation completes the terminal.